Gridfinity Bins & Baseplates

A clean starter set for the open Gridfinity standard (42 mm grid, 7 mm height units). Bins lock into the baseplate so nothing slides around in the drawer, and they stack on top of each other.

BINS (width x depth x height units)
- 1x1x3, 1x1x6, 1x2x3, 1x3x3, 2x2x3, 2x2x6
- 2x1x3 with 2 compartments, 3x2x3 with 3 compartments
- Rounded inner floor edge and a finger scoop at the front, so small parts (screws, bits, beads, SD cards) slide out easily

BASEPLATES
- 3x3, 4x4 and 5x4 in a lightweight frame style (fast, little filament). Place several side by side to fill a drawer.

PRINTABILITY
- No supports, no brim. Nothing steeper than 45°: the stacking lip sits on a 45° support, the feet have 45° chamfers.
- Fit checked against the standard profile: bins seat in the baseplate with 0.1–0.25 mm clearance and stack on bins of the same footprint.
- Compatible with other Gridfinity bins and baseplates.

PRINT SETTINGS
PLA or PETG · 0.2 mm · 2 walls · 15 % infill · no supports · print as oriented.
Sliced in Bambu Studio without warnings. Estimated print time: 1x1x3 about 22 min (10 g), 2x2x3 about 46 min (31 g), 4x4 baseplate about 38 min (17 g).

• grundplatten/gridfinity_baseplate_3x3.stl 412 KB
• grundplatten/gridfinity_baseplate_4x4.stl 769 KB
• grundplatten/gridfinity_baseplate_5x4.stl 958 KB
• kaesten/gridfinity_bin_1x1x3.stl 187 KB
• kaesten/gridfinity_bin_1x1x6.stl 187 KB
• kaesten/gridfinity_bin_1x2x3.stl 225 KB
• kaesten/gridfinity_bin_1x3x3.stl 260 KB
• kaesten/gridfinity_bin_2x1x3_2fach.stl 231 KB
• kaesten/gridfinity_bin_2x2x3.stl 296 KB
• kaesten/gridfinity_bin_2x2x6.stl 296 KB
• kaesten/gridfinity_bin_3x2x3_3fach.stl 386 KB